Sears T1KB2/T1RFKB2 Guía de uso y cuidado descargar pdf (Pagina 15)

3. With the cap in a horizontal position, insert the cap into the

base grille until it stops.

4. Turn the cap counterclockwise until the cap slips into the

attachment slot. Then, turn the cap clockwise until it is in a

horizontal position.

NOTE: The cap will not be even with the base grille.

Ice Maker and Storage Bin

(on some models - Accessory)

Turning the Ice Maker On/Off

NOTE: Do not force the wire shutoff arm up or down.

The On/Off switch for the ice maker is a wire shutoff arm located

on the side of the ice maker.

1. To turn the ice maker on, simply lower the wire shutoff arm.

NOTE: Your ice maker has an automatic shutoff. As ice is made,

the ice cubes will fill the ice storage bin and the ice cubes will

raise the wire shutoff arm to the OFF (arm up) position.

2. To manually turn the ice maker off, lift the wire shutoff arm to

the OFF (arm up) position and listen for the click to make sure

the ice maker will not continue to operate.

Increasing Ice Production Rate

The ice maker should produce approximately 7 to 9 batches of ice

in a 24-hour period. If ice is not being made fast enough, turn the

Freezer Control toward a higher (colder) number in half number

steps. (For example, if the control is at 3, move it to between 3 and

4.) Wait 24 hours between each increase.

Remember

■ Allow 24 hours to produce the first batch of ice. Discard the

first three batches of ice produced.

■ The quality of your ice will be only as good as the quality of the

water supplied to your ice maker. Avoid connecting the ice

maker to a softened water supply. Water softener chemicals

(such as salt) can damage parts of the ice maker and lead to

poor quality ice. If a softened water supply cannot be avoided,

make sure the water softener is operating properly and is well

maintained.

■ Do not store anything on top of the ice maker or in the ice

storage bin.

REFRIGERATOR FEATURES

Your model may have some or all of these features. Features that

can be purchased separately as product accessories are labeled

with the word “Accessory.” Not all accessories will fit all models. If

you are interested in purchasing one of the accessories, please call

the toll-free number on the back cover or in the “Accessories”

section.

Refrigerator Shelves

Your model may have glass or wire shelves. Store similar foods

together and adjust the shelves to fit different heights. This reduces

the time the refrigerator door is open and saves energy.

Shelves and Shelf Frames (Fixed and Slide-out)

To Remove and Replace a Shelf:

1. Pull the shelf forward to the stop. Tilt the front of the shelf up.

Lift to remove from the shelf supports.

2. Replace the shelf/frame by aligning the shelf with the shelf

supports. Slide the shelf onto the shelf supports. Be sure that the

shelf is securely in position.

Important information to know about glass shelves

and covers:

Do not clean glass shelves or covers with warm water when

they are cold. Shelves and covers may break if exposed to

sudden temperature changes or impact, such as bumping.

Tempered glass is designed to shatter into many small,

pebble-size pieces. This is normal. Glass shelves and covers

are heavy. Use both hands when removing them to avoid

dropping.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Comentarios a estos manuales

Sin comentarios

Sears T1KB2/T1RFKB2 Guía de uso y cuidado Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras Sears T1KB2/T1RFKB2